8/30/2023 0 Comments Transfer paper for vinyl![]() When I first got started with transfer tape, I was terrible at it and I didn't really understand it either. This has helped me a lot! Again, you can use this tip for when you are removing the paper backing from the vinyl and also when you are removing the tape from your surface (as seen above). Do you see how I'm pulling the transfer tape across the chalkboard? Now that we've got our 45-degree angle and we are rocking back and forth slowly, it's also important to pull tightly, almost just dragging it across the surface you are working on. If I had to pick one tip to share with you today, this would be one of the most important in my book. I don't really know why this helps to be honest, but I've found it to be extremely helpful!ĥ. Pull down tightly, keep your paper almost level with your surface. As I'm removing the paper that the paper that the vinyl was adhered too, I like to gently rock the 45-degree angle back and forth slowly. Rock your 45-degree angle back and forth (left-to-right/right-to-left) as you go. You'll obviously start this way since you're starting in a corner but I like to continue using this angle as I'm removing it.Ĥ. This has helped me SO much! First, pick a corner and remove at a 45-degree angle. When removing the tape, pull down at a 45-degree angle. This will help will getting the vinyl to stick to the tape.ģ. ![]() Burnish your tape on the front AND back using a scraper tool.Īfter you've got your tape on your design, make sure you are burnishing (rubbing) on the front and back of the vinyl/transfer tape combination. This tip works for both when you apply the tape on top of the vinyl (as seen above) and also when you're applying it onto your surface.Ģ. The end goal here is to get your tape applied evenly on the vinyl so that you can successfully transfer it to your blank. It also may not apply correctly onto the vinyl and you can potentially risk your project. If you don't get it applied evenly, then you're at risk for having kinks in the tape and the vinyl. ![]() Slow is key here! This way you will get everything applied evenly. It can be so tempting to just want to throw the transfer tape on carelessly- been there! When you're applying it, I like to start at one end, push down a little and then slowly apply the rest as you make your way down. When applying transfer tape, start at one end and slowly place it down. Cricut beginners - this one's for you! Are you struggling with using transfer tape on vinyl? We have ten tips to hopefully help you get successful transfers.ġ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |